The XC9116 series is a fixed frequency, constant current step-up DC/DC converter ideal for driving LEDs used in backlighting applications on cellular phones, PDAs and digital cameras etc. Output voltage of up to 17.5V can be derived, therefore, four white LED's in series can be driven. Since an LED current can be set up by an external resistance when LEDs are in-series connection, all white LEDs can be turned on equably. A network of two parallel legs with three in each LED can be also driven. Luminance of the LED's is controlled by changing the duty cycle of a PWM signal applied to the CE pin. Efficiency is high with the XC9116 through the high 1.0MHz switching frequency and the low feedback reference voltage, ensuring the RLED losses are minimal. In addition, an internal MOSFET with an RDSON of 2.0 is used. A low profile and small board area solution can be achieved using a chip coil and an ultra small ceramic output capacitor (CL) of 0.22F. The 'B' type of XC9116 has an additional fault detection circuit. If the LEDs are disconnected or damaged in such a way that prevents feedback, excess or run away output voltage is prevented by stopping the drive to the internal MOSFET.