ChipDocs - Datasheet Source for Semiconductor and Electronic Circuit Components
More than
4 307 195 
components listed
Partname:5962-9321603QHA
Description:High Speed High Drive Precision Dual Operational Amplifier
Manufacturer:Texas Instruments
Datasheet:PDF (1.28M).
Click here to download *)

The TLE214x and TLE214xA devices are high-performance, internally compensated operational amplifiers built using Texas Instruments complementary bipolar Excalibur process. The TLE214xA is a tighter offset voltage grade of the TLE214x. Both are pin-compatible upgrades to standard industry products. The design incorporates an input stage that simultaneously achieves low audio-band noise of 10.5 nV/Hz with a 10-Hz 1/f corner and symmetrical 40-V/s slew rate typically with loads up to 800 pF. The resulting low distortion and high power bandwidth are important in high-fidelity audio applications. A fast settling time of 340 ns to 0.1% of a 10-V step with a 2-k/100-pF load is useful in fast actuator/positioning drivers. Under similar test conditions, settling time to 0.01% is 400 ns. The devices are stable with capacitive loads up to 10 nF, although the 6-MHz bandwidth decreases to 1.8 MHz at this high loading level. As such, the TLE214x and TLE214xA are useful for low-droop sample-and-holds and direct buffering of long cables, including 4-mA to 20-mA current loops. The special design also exhibits an improved insensitivity to inherent integrated circuit component mismatches as is evidenced by a 500-V maximum offset voltage and 1.7-V/C typical drift. Minimum common-mode rejection ratio and supply-voltage rejection ratio are 85 dB and 90 dB, respectively. Device performance is relatively independent of supply voltage over the 2-V to 22-V range. Inputs can operate between VCC - - 0.3 to VCC + - 1.8 V without inducing phase reversal, although excessive input current may flow out of each input exceeding the lower common-mode input range. The all-npn output stage provides a nearly rail-to-rail output swing of VCC - - 0.1 to VCC + - 1 V under light current-loading conditions. The device can sustain shorts to either supply since output current is internally limited, but care must be taken to ensure that maximum package power dissipation is not exceeded. Both versions can also be used as comparators. Differential inputs of VCC can be maintained without damage to the device. Open-loop propagation delay with TTL supply levels is typically 200 ns. This gives a good indication as to output stage saturation recovery when the device is driven beyond the limits of recommended output swing.

Click here to download 5962-9321603QHA Datasheet
Click here to download 5962-9321603QHA Datasheet
*)
*)Datasheets downloading from ChipDocs is only for our members (paid service). REGISTER NOW for your membership.
Free Electronics Engineering Subscription
Win Win Circuit - PCB,PCBA,Touch Screen,LED Lighting
Win Win Circuit LTD. PCB, PCBA, LCD Module
www.wwteq.com
COPYRIGHT 1997-2024 ChipDocs  ALL RIGHT RESERVED