The device implements a three phase step-down controller with a 120 phase-shift between each phase with integrated high current drivers in a compact 7x7mm body package with exposed pad. The device embeds selectable DAC: the output voltage ranges from 0.8185V to 1.5810V with 12.5mV steps (VID_SEL=OPEN) or from 0.800V to 1.550V with 25mV steps (VID_SEL=GND; VID5 drives an optional +25mV offset) managing dynamic VID with 0.5% accuracy over line and temp variations. Additional programmable offset can be added to the voltage reference with a single external resistor. The device assures a fast protection against load over current and load over/under voltage. An internal crowbar is provided turning on the low side mosfet if an over-voltage is detected. In case of over-current, the system works in Constant Current mode until UVP. Selectable current reading adds flexibility in system design.