The LT1025 is a micropower thermocouple cold junction compensator for use with type E, J, K, R, S, and T thermocouples. It utilizes wafer level and post-package trimming to achieve 0.5C initial accuracy. Special curvature correction circuitry is used to match the "bow" found in all thermocouples so that accurate cold junction compensation is maintained over a wider temperature range. The LT1025 will operate with a supply voltage from 4V to 36V. Typical supply current is 80A, resulting in less than 0.1C internal temperature rise for supply voltages under 10V. A 10mV/C output is available at low impedance, in addition to the direct thermocouple voltages of 60.9V/C (E), 51.7V/C (J), 40.3V/C (K, T) and 5.95V/C (R, S). All outputs are essentially independent of power supply voltage. A special kit is available (LTK001) which contains an LT1025 and a custom tailored thermocouple amplifier. The amplifier and compensator are matched to allow a much tighter specification of temperature error than would be obtained by adding the compensator and amplifier errors on a worst-case basis. The amplifier from this kit is available separately as LTKA0x. The LT1025 is available in either an 8-pin PDIP or 8-pin SO package for temperatures between 0C and 70C. , LTC and LT are registered trademarks of Linear Technology Corporation.